51 To 66
Automatic Hydraulic Harrow Drawbar
Let your hydraulic system do the work for
you! When equipped with our HD-1100A Automatic Kit, you are in
complete control from the tractor seat.
Folding the unit into Field Position:
Back the unit up until the wings position themselves in line with the
center boom. Lower the sections to the ground with your hydraulic
system. You are now ready to harrow.
Folding into Transport Position:
Raise the sections to vertical position. Drive forward and the wings
will pull into transport position and you are ready to hit the road.
Now, if you so desire, you can save
around $650 by omitting the HD-1100A Automatic Pull Cable Kit. This
will make the unit Semi-Automatic, which means when you are in
transport, you will have to get off the tractor to remove the cables
from the section lift arm hooks and put the pull cable eyes in the
pull cable plate at the front of the harrow cart before opening the
unit. When going from field position into transport position, you will
again need to get off of the tractor and pull the pins back out of the
pull cable plate and hang the cables on the section lift arm hooks
before pulling the unit forward into transport mode. This is obviously
an option, but we truly feel your needs are best served with the
46-965 Hydraulic Drawbar with 6
channel cart sides for extra strength and a 16 Hydraulic cylinder are
46-960, 46-965 and 46-1165 are one
section wide in transport position.
All units are available with the HD-1100A Automatic Kit.